Bionet BM5VET, Руководство по эксплуатации

Страница: 114 / 227

114
BM5Vet Pro User’s Manual
A-4-6. LAST ZERO TIME This is the total time that has elapsed
with the sensor in service since the last
zero. Min. display
A-4-7. PUMP TOTAL TIME This is the total time the pump has
been on. (LoFlo only) Min. display
A-4-8. PUMP MAX TIME This value indicates the maximum
rated lifetime of the sampling pump.
(LoFlo only) Min. display
A-5. MODULE SETUP Module Information Menu
A-5-1. CURRENT PERIOD This setting is used to set the
calculation period of the ETCO
2
value.
The end-tidal CO
2
value is the highest
peak CO
2
value of all end of
expirations (end of breaths) over the
selected time period. If less than two
breaths exist in the selected time
period, the value will be the maximum
ETCO
2
value for the last two breaths.
1 BREATH,
10SEC,
20SEC
A-5-2. BALANCE GAS This setup mode to setup the gas in
the measurement; the type of gas that
is mixed with the breathing gas
measuring ROOM AIR
N2O
HELIUM
A-5-3. SLEEP MODE Sleep mode is used to save power
when the host monitor is in standby
mode. There are two sleep modes
available for the Capnostat. Using
Sleep Mode 1 maintains the heaters,
so the Capnostat can run immediately
after exiting the sleep mode. Mode 2
will require the Capnostat to go
through its warmup sequence when
exiting this mode and a delay will be
introduced until the system has
stabilized. NORMAL MODE
TURNOFF MODE
POWER SAVING
A-5-4. BARO. PRESSURE This setting is used to set current 760mmHg