BIG BALE Transtacker 4100, Руководство по эксплуатации и обслуживанию, Страница: 22 / 88

5.0 Operation
5. 1 5 Stacking (Automatic)
1. Before operating the stacking function, ensure the
following:
A. The pickup has returned fully (Fig. 63 ) .
B. The table is full and the bales are tight, central and well
aligned. This is very important (Fig. 64 ).
Fi g. 47 No te 1
Note the alignment with the sides of the platform.
F ig. 47 N ote 2
The Bales must be tightly packed together, tight up against
the bale stop and central to the machine.
Fi g. 47 N ote 3
Location of Bale Stop. See Adjustments Section 6.0
C. Ensure the forks are erect, pressurised and forward .
D. Check the rear clamp s is fully open . See 5.13 Getting
Started Manually
E. Ensure you are in 'Field Manual Mode' (Fig. 1 2 ) .
2. Pull the joystick back (Fig. 65 ) to start an 'Auto Stack' and
the machine will place the first line of bales on the platform
against the forks and return to its lower position on the nylon
bottom stops with the hooks withdrawn.
Note: The 'Auto Stack' will know if it should 'Tie' or 'No Tie'
due to how you set your bale configuration.
Note : The side gate tines should grip the bales and prevent
them falling forward. The 'Side Gates' should open and close
automatically to suit.
3. View the Screen on the control panel, this will have
progressed to indicate one layer of bales.
4. Repeat the above process until the platform is full. This
will be indicated by the LCD flashing full.
The Transtacker
4100 will then automatically go into 'Road Mode'.
1 2 3
Fig. 64
Pick up
Fig. 63
Fig. 65
19