BIG BALE Transtacker 4100, Руководство по эксплуатации и обслуживанию, Страница: 15 / 88

5.0 Operation
5.8 Erecting a Complete Tower
Manoeuvre the machine to the stack site. Check the
following:
A. The ground is firm and flat and not sloping excessively to
either side or forward i.e. more than 5°.
B. Check there are no overhead obstacles or power lines. It
is recommended to keep 10 meters away from power lines.
C. Check the load is still secure within the Transtacker.
D. Check there are no by-standers, animals or property th at
will be damaged if any bales were to fall.
1. Press and hold button to exit ‘Road Mod e' and enter
'S tack Manual M ode ' ( Fig. 12 ) if required.
2. Pull the joystick bac k (Fig. 26 ) to pe rform 'Auto Tip Bed
Up'. Before the 'Platform' starts to raise, the Transtacker will
automatically lower your forks and bring them to the front.
The 'Platform' wont raise until the left and right 'Forks
Forward' sensor has been met. Be careful that the top bales
remain secure on the 'Extension Frame' during the first
stages of tipping.
3. When the p latform is half raised, the curved skids wi ll
contact the ground ( Fig. 27 ) . At this point release the
brakes , dip the clutch and allow the machine to roll back as
the platform is raised .
4. Continue to raise the stack until you are satisfied it is
vertical and secure.
5. Move the joystick left and righ t (Fig. 28 ) to open the side
gates.
6. Hold the 'BLACK' button on the joystick and push forwa rd
to release the 'H ooks ' (Fig. 29 ) .
7. Keep the 'BLACK' button held down and move the
joysti ck left (Fig. 30 ) to lower the 'Turnt able ' and lift off the
stack.
8. Keep the 'BLACK' button held down and move the
joystick right (
Fig. 31 ) to extend the 'Extension Frame' and
'Turntable'.
9.. Still holding the 'BLACK' button move the joystick back
(
Fig. 32
) to remove the 'Rear Clamps'.
Curved skid
Fig. 26
Fig. 27
Fig. 28
Fig. 29
Fig. 30
Fig. 31
Fig. 32
12