Berger Lahr WDP3-01X, Руководство пользователя

Страница: 89 / 114

Clearing an error
The error codes in the status display or error memory can be cleared by
pressing .
After clearing the error code, “Err”, “OFF” or “run” appears in the status
display.
Display
Cause Rectification
The error codes “11”,
“12” or “14” are cleared. Eliminate the cause of the
error (see troubleshooting
table) and activate the
ERR_RESET input.
One or more error codes
are cleared. Eliminate the cause of the
error (see troubleshooting
table) and switch the 24 V
supply voltage for the
processor unit off and on
again.
Controller ready. –
Other malfunctions
The following table lists possible malfunctions which are not indicated.
Malfunction Cause Rectification
Motor does not move
even with current
available Motor is mechanically blocked Release motor brake, if available.
No motor torque One or more motor leads
interrupted Check motor wiring; see chapter 2.4.
Motor does not move
Motor does not follow
control Motor leads interchanged, or
one or more motor leads
interrupted
Motor and positioning controller
do not match Use the proper motor type; see chapter 6.1.
DANGER
The mains supply voltage must be disconnected for any check on
the mains, motor, or bleed resistor wiring.
Malfunctions
WDP3-01X Ident. no.: 00441109760 4-5