BeneVision TM80, Руководство оператора

Страница: 176 / 240

15 - 2 BeneVision TM80 Telemetry Monitor Operator’s Manual
The telemetry
monitor cannot be
connected to the
Central Station
wirelessly and the
wireless symbol on
the main screen of
the telemetry
monitor is
displayed
as
.
The wireless access point (AP) in
the vicinity is not enabled. Make sure that the wireless access point
is enabled and belongs to the Virtual
LAN (VLAN) where the telemetry
monitor is covered.
The telemetry monitor is not
powered on under the AP
coverage area. Put the telemetry monitor within the
wireless access point coverage area
and restart it. Ensure that the signal
strength displayed on the telemetry
monitor is greater than -65dBm.
Items like SSID, WMTS band are
not configured correctly for the
telemetry monitor. Contact your service personnel.
Items like SSID, WMTS band are
not configured properly for the
wireless access point.
The telemetry monitor has a
fault.
The telemetry
monitor has been
connected to the
wireless network
but cannot be
connected to the
Central Station. The telemetry monitor is not
admitted by the Central Station
yet.
Failed to acquire the IP address.
Static IP conflict
Single telemetry
monitor is offline
occasionally. The telemetry monitor is located
in the blind area of wireless
coverage.
The telemetry monitor has a
fault.
Static IP conflict
Some telemetry
monitors are
offline
occasionally. The wireless access point in
some area is damaged.
Severe interference occurs in
some areas.
The signal strength is weak
some areas.
All the telemetry
monitors are
offline
occasionally. Partial wired network is not
configured properly.
Wireless interference
Symptom Possible cause Solution