Beer Grill AG
Beer Grill GmbH
Allmendstrasse 7
Tel. +41 56 618 7800
Körnerstrasse 14 a
Tel. +49 71 61 659 876
CH
– 5612 Villmergen,
Switzerland
Fax +41 56 618 7849
D
– 79539 Lörrach,
Germany
Fax +49 71 61 659 879
www.beergrill.com
Assembly-Programming-Instructions_Cold-Rack_e_05-10-2018
Page 5
1.3 Preparation
The refrigerated showcases are easy to install with a minimum of tools and can be placed
on any type of substructure/floors that are strong enough.
For protection, the refrigerated showcase has been provided with a working plastic
protective film. Remove this from the refrigerated appliance. Your refrigerated appliances
should work efficiently.
Any qualified person can complete the major part of the installation. However, all electrical
installations must be carried out by a qualified electrician. Ensure that suitable personnel
and tools are available to prevent damage and injury.
All appliances require a 230 volt power supply. The settings for the appliances can be found
in the enclosed programming manual. As a result of condensation, all refrigerated
appliances must have an external condensation drain or a condensation tray.
1.4 Mobile version
In the case of mobile appliances, the castors must be braked after the appliance has been
placed in its final position.
1.5 Installation options
The appliances can be placed in a niche provided by the customer. The appliance can be
placed directly on the floor or on an elevated surface. Note that a service door as well as
access to the cooling unit and control system are provided on the customer side.
For the dimensions of the appliance, please refer to the order or the attached product
sheets.
1.6 Connection to the customer's integrated system
In the case of centrally cooled appliances, the solenoid valve must be provided by the
customer. Beer Grill attaches the corresponding electrical valve and the injection nozzle
separately to the appliance for customer connection to the integrated system.
Before fixing the refrigerated appliance in place, check again that it is correctly
aligned. The condensation drain must be the lowest point in the inner tank. Check
that water can drain out from the inside of the tank.
!
