Baroness LM2700, Руководство по обслуживанию

Страница: 292 / 325

Important
Be sure to replace the bearings and oil seals
with new ones.
Apply a profuse amount of grease on new
bearings and oil seals.
To bearings, apply grease like rubbing until
the grease leaks from the other side.
Also apply a profuse amount of grease to the
lip of the oil seal.
1
2
uxqrbr-002
Groomer Assy_013
1 Ball bearing
2 Oil seal
Drive in the bearings and oil seals.
Note:
Use a bearing driver to drive in the bearings
and oil seals.
3
4
2
1
t7ajai-013
Groomer Assy_014
1 Groomer case
2 Bearing Driver
3 Plastic hammer
4 Oil Seal Installer
10.
11.
Install the groomer following the reversed
procedure of the procedure 2 to 8.
Fill approximately 60% of the groomer case
with grease.
When installing the groomer to the mower
unit, be sure to adjust the left and right nuts
so that the groomer blades fit into the
grooves of the front roller.
1 1
t7ajai-014
Groomer Assy_015
1 Nut
Adjust the length of the spring of the height
adjustment bolt to 45.0 mm (1.77 in) with the
pipe with adjusting screw.
1
45mm
t7ajai-015
Groomer Assy_016
1 Pipe with adjusting screw
Install the clutch lever onto the groomer
case.
Make sure that the spline shaft and groomer
shaft can be turned ON or OFF by the clutch
lever.
Install the groomer.
12.
13.
14.
15.
16.
17.
18.
LM2700
Operating Machine and Mower Units
Page 8-44 Inspection and repair of each section