Baroness LM2700, Руководство по обслуживанию

Страница: 219 / 325

1 Spring pin
2 Pin puller
Important
The thrust bearing has a specific installation
direction. (The outer and inner dimensions
are different from each other.)
Check the direction when removing the thrust
bearing.
Follow the steps below to remove the
kingpin-left.
Remove the collar and the cap.
Remove the kingpin-left from the pivot.
Remove the thrust bearing and O-ring.
3
4
5
6
2
1
flixj7-004
Removal of Kingpin-Left_002
6.
[1]
[2]
[3]
1 Collar
2 Cap
3 Kingpin-left
4 Pivot
5 Thrust bearing
6 O-ring
Installation of Left Kingpin
Caution
Exercise care in handling the kingpin since it
is heavy.
Caution
See the list in "Tightening torques" (Page
3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Make sure of the slot position of the spring
pin and do not install them at the wrong
locations.
Important
The thrust bearing has a specific installation
direction. (The outer and inner dimensions
are different from each other.)
Install the thrust bearing in the correct
orientation.
Follow the steps below to install the
kingpin-left.
Apply grease to the shaft of the kingpin-
left.
Apply grease to the O-ring and thrust
bearing, and then install them on the
shaft of the kingpin-left.
Make sure that the kingpin-left is securely
inserted in the pivot.
Install the cap and collar.
1.
[1]
[2]
[3]
[4]
Main
bo
dy
LM2700
Main body
Page 7-25 Removal and installation of each section