Baroness LM2700, Руководство по обслуживанию

Страница: 180 / 325

Starter Relay
Starter relay is located on the operation panel,
and it controls starting of the starter by receiving
signal from the safety switch.
Wiring from the safety switch is connected to the
alternator L-terminal (grounded at starting) via
the relay.
The starter can be started only when the safety
switch and the alternator are working properly.
1
ipzeta-001
Starter Relay_001
1 Starter relay
Glow Lamp Timer
The glow lamp timer is located on the operation
panel and controls illumination of the thermo-
start lamp.
1
yvr8dl-001
Glow Lamp Timer_001
1 Glow lamp timer
When the ignition key is set and held to the
"GLOW" position, the thermo-start lamp turns on
for 5 seconds.
The timer unit is activated with the "glow" and
"starter start" signals from the ignition key
switch.
When the glow signal is inputted, the thermo-
start lamp turns on (5 seconds).
When the ignition key is set to the "START"
position (starter motor start), even during the
period of the thermo-start lamp turning on
(before 5 seconds pass), the starter start signal
is inputted and the lamp is turned off.
If the timer unit malfunctions, the lamp will not
turn on; however, this will not affect engine
starting.
START
ON
OFF
GLOW
ON
OFF
Ignition key
Glow lamp
5 second
yvr8dl-002
Glow Lamp Timer_002
Fusible Link
The fusible link acts as a main fuse for the entire
circuit and a fuse for the charging circuit.
Located in the right hood, it is equipped with a
specialized fuse (50 A) cartridge.
1
1qgabk-002
Fusible Link_001
1 Specialized fuse
LM2700
Electrical system
Page 6-32 Electrical components