Barco Event Master E2, Руководство пользователя

Страница: 104 / 307

6. GUI orientation
It is possible that after the unit is turned on, the hardware con fi guration can be altered making certain Destinations to have invalid
Output con fi gurations.
In this case the Destination in the System Diagram becomes grey and adjustment are disabled. In this case the destination needs
to be deleted and new one created to re
fl ect the existing output con fi guration.
How to add Destination
To assign an output con fi guration to a destination, select the output con fi guration (output Tab) and then click on the Add Screen
Destination or the Add Aux Destination button (Destination Tab). These buttons are enabled (highlighted in blue) as long as there
are unassigned output con fi gurations.
Image 6-27
If the Add destination button is pressed without selecting an output con fi guration, the software will automatically assign the fi rst
unassigned output con fi guration (from left most output card) to a destination. The output con fi guration format is copied to the desti-
nation output format.
New Screen or Aux destinations can be added as long as there are unassigned output con fi gurations to destinations.
Alternatively, you assign outputs to destinations by dragging them into the output con fi guration the Destination block. In the example
below, the output 1 was assigned to ScreenDest1 and the destination format was set to 1920x1080 re fl ecting the format of output1.
When output 2 is dragged into the same destination, then the format changes to 3820x1080 re fl ecting a 2x1 setup. When outputs
are dragged into a destination in this matter, the software assumes it is a horizontal setup with 0 pixel overlap. The overlap can
be modi
fi ed in the … menu. If a vertical setup is desired, then the output con fi guration needs to be setup as such in the output
con fi guration menus.
Image 6-28
How to delete Destination
1. Click on the Delete Destination(s) button
The Delete Destination(s) button is replaced by the Delete Selected button (highlighted in red) and the E2 diagram is greyed
out, except the area dedicated to destinations (Screen and Aux).
2. Click on destination in the graphical area.
100 R5905948 E2 12/12/2014