Banner iVu Plus BCR, Руководство пользователя

Страница: 86 / 155

Command Channel Command Status
The command status is either OK or ERROR. If OK, then the command has fully and successfully completed. If an error is returned it is in
the form ERROR nnnnn_ERROR_IDENTIFIER (for example ERROR 10001_COMMAND_NOT_RECOGNIZED). Refer to
Command
Channel Error Codes on page 97 for a list of errors.
8.2 Conventions Used for Examples
There are a number of command channel examples included here, and the following are the conventions used in the examples:
• All examples use <CR><LF> for the end-of-frame delimiter, and this delimiter is always denoted in hex (\x0D\x0A) since that is what
is displayed in the iVu logs and, for example, the Port Status screen.
• All commands are in bold text.
• For each example, a command request to the iVu sensor is prefaced with a >>, and a command response frame from the iVu sensor
is prefaced by a << as shown below. These are only used to make the documentation clearer.
>> get info companyname \x0D\x0A
<< OK\x0D\x0A
<< "Banner Engineering Corp."\x0D\x0A
8.3 Examples
8.3.1 Example 1: How to Trigger the Sensor and Retrieve Barcode Data using the Com-
mand Channel
To trigger the sensor and retrieve barcode data, do the following
1. Set Trigger to Command. Go to the Main Menu > Imager > Trigger screen, and from the drop-down select Command
2. Issue a trigger command as follows:
>> do trigger \x0D\x0A
<< OK\x0D\x0A
3. Check that the inspection passed.
>> get inspection status \x0D\x0A
<< OK\x0D\x0A
<< Pass\x0D\x0A
4. Get the barcode data read by the iVu sensor.
>> get bcr_result \x0D\x0A
<< OK\x0D\x0A
<< "0043000011201"x0D\x0A
8.3.2 Example 2: How to Modify Barcode Compare Data Using the Command Channel
1. Set Trigger to Command. Go to the Main Menu > Imager > Trigger screen, and from the drop-down select Command
iVu Plus BCR User's Manual
86 www.bannerengineering.com - tel: 763-544-3164 Rev. B