TELEPHONE HYBRID REMOTER DETAIL
| TELEPHONE HYBRID REMOTER DETAIL
53
14.11.3
Outputs Section
This section includes the parameters to change the output operating mode. It is divided into two sections: Digital Output
and Analog Output
DIGITAL OUTPUT
Nominal Output Level:
This parameter changes the nominal level of the AES/EBU output. Range
of allowed values: from -24.0 dBFs to a maximum of -5.0 dBFs. This
parameter can be used to change the digital output of Hybrid 1 and
Hybrid 2.
Frequency
: output frequency of the AES/EBU digital signal. Values
allowed: 32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz, 96kHz.
Resolution
: parameter used to set the resolution of the AES/EBU output
digital signal. Values allowed: 16bit, 20bit, 24bit.
Output Mode:
in this box it is possible to select which of the two audio outputs from the two Hybrids must be sent to the
AES/EBU output. The output of Hybrid 1 (L = R = Hybrid 1) or the output of Hybrid 2(L = R = Hybrid 2) can be equally
sent on the Left and Right, or the two Hybrid can be summed (L = R = Hybrid 1 + Hybrid 2) to send to the AES/EBU
digital output the sum of the two telephone Hybrids.
ANALOG OUTPUT
Nominal Output Level:
This parameter changes the nominal level of the Left + Right analog output.
Range of allowed values: from -10.0 dBu to a maximum of +14.0 dBu. This
parameter can be used to change the Left + Right analog output of Hybrid 1
and Hybrid 2.
Conference
: When this checkbox is flagged the conference operating mode is
enabled. This mode foresees that the two Hybrids communicate with each
other and that the sum of the outputs of the two Hybrids can be taken from the
analog
Receive
output of Hybrid 1 or from the analog
Receive
output of Hybrid
2.
See the
Special notes concerning Ducking/Conference between Hybrids
to disable this parameter when the device is
used in certain configurations.
UNDO:
press UNDO to reset the values set in the whole Hybrid 1, Hybrid 2 and Outputs
section to the values set on the device before the opening of the control panel.
