USE OF THE PHONEX ADDRESS MANAGER SOFTWARE
| USE OF THE PHONEX ADDRESS MANAGER SOFTWARE
30
11
USE OF THE PHONEX ADDRESS MANAGER SOFTWARE
The PhoneX Address Manager software assigns a TCP/IP address, the relevant Subnet Mask, a Gateway and a port to
PhoneX
. This is obtained using the PC’s serial port on which PhoneX Address Manager is installed and the
SERIAL-1
port of the PhoneX device. The following screen will appear when you open the program:
The PhoneX Address Manager is still disconnected from the
PhoneX device, in fact the values of the Ethernet port are still
grey. Click
CONNECT
to connect the PC to PhoneX; the
Ethernet port values will show on the PhoneX Address
Manager of PhoneX. The default values of the COM port are
38.400bps 8-N-1
If the USB port is used to connect the device, it must be
selected the COMx (VCOM USB PORT) that is the virtual
COM to USB port.
Once the PhoneX Address Manager has been connected to
PhoneX the Ethernet port values are displayed. To change
these values position the cursor in the relevant fields and
enter the port data, then click
SEND DATA
to send the changes to PhoneX.
To check whether the changes have been made click
RELOAD DATA
, which refreshes the program which then
reads the port values again.
With this program it is possible to set the Read Password
and Write Password of communication via the
SNMP
protocol. The default setting is:
Read Password:
public
Write Password:
private
Information concerning the device connected is available in the lower part of the software, above the
command keys. Data such as the “
Connected Target
” is available; this shows the device model
connected and the
firmware release installed
(v2.0.0). The
Firmware Code
is also shown, which
indicates the univocal progressive number of the firmware and hardware installed on the device. This
number could be required for an upgrade of the device or in the case of specific requirements or
customisations..
