TELEPHONE HYBRID REMOTER DETAIL
| TELEPHONE HYBRID REMOTER DETAIL
44
14.6 PHONEX CONTROL SOFTWARE DESCRIPTION
Phonex control software description
The PhoneX control software (PhoneX Remoter) is basically divided into 5 parts:
5.
Hybrid 1
section
6.
Hybrid 2
section
7.
Levels
section
8.
GPI / GPO status
section
9.
Setup
&
Disconnect
section
14.7 HYBRID 1 SECTION
The “
Hybrid 1 Section
” features a series of operating and monitoring controls relating
to the first telephone hybrid connected to a PSTN/POTS line.
The monitoring part concerns the Receive and Send levels and shows whether
PhoneX is in Ducking and Limiting operating mode; it also shows the line status, ring,
echo canceller and if the denoiser is active.
As regards device operation, the controls available are:
ON HOOK
– ATTEN – HOLD – DIAL
ON HOOK
: in this status PhoneX can hook an incoming call or open the telephone line. Upon
receipt of a call the LED of the incoming call flashes and the PhoneX Remoter displays the
RINGING Line Status for the hybrid with the incoming call. The relevant RING LED lights up in the
GPO Status and Line Status sections. The relevant relay of the Opto Interface Hybrid
communication port closes. See the appendix at the end of this manual for the pinout and
connections.
To end a call press OFF HOOK.
ATTEN
: when ATTEN is pressed via software or via GPIn connection, a
dB reduction equal to the Ducking value set in the control software is
applied to the Receive signal.
HOLD
: when HOLD is pressed via software the Receive volume is taken to
–
infinity without closing the call.
