TELEPHONE HYBRID REMOTER DETAIL
| TELEPHONE HYBRID REMOTER DETAIL
37
14.4 GPIO STATUS SECTION
The GPI / GPO Status section shows the status of the General Purpose Input and Output
status. The 25 pin female SubD port on the back of the device is used to connect the device;
see the technical appendix for the connections and the pinout.
14.4.1 GPI status function
HOOK 1:
this is used to hook, by means of a stable contact, the telephone line of Hybrid
1
; it
is usually connected to the
TELCO (N-1)
modules of the Broadcast Mixing consoles that
feature a
GPO
contact to answer incoming calls directly from the telephone fader.
ATTEN1:
The closure of this GPI, corresponds to the execution, by the PhoneX, of the
ATTEN
command available via REMOTER control software or via web page; in other words “
a dB reduction equal to the
Ducking value set in th
e control software is applied to the Receive signal”
. A connection to the
GPOs
provided by the
mixing consoles or by commands made available to the broadcast technician or director of a programme on air, if the
audio received needs to be attenuated. This is not a profanity delay
HOOK 2:
Not available in PhoneX D1, it looks like grey in the software below
ATTEN2:
Not available in PhoneX D1, it looks like grey in the software below
14.4.2 GPO status function
GPOUT 1:
by using this monitor, it is possible to see when PhoneX D1 close
a Gpout in the GPIO port. The GPOut is available via Open Collector, and
further capabilities are available in the “Program Settings” and to each
GPOut it is possible to associate some function, below explained:
OFF:
take no action
Hook1:
Once a phone calling is hooked, this Gpout stay closed for all the
calling long, until the phone calling is closed.
Ring1:
When a phone calling is coming (Ring) this GPout change its status. This one is generally connected to an optical
alarm repeater, to shows the incoming call. This one is generally connected to Telco N-1 module in Broadcast console.
Hook2:
Not available on PhoneX D1
Ring2:
Not available on PhoneX D1
DTMF Fun1:
when a DTMF signal is received composed by a string of N numbers, it can be associated a particular
functionality thanks to the internal DTMF decoder.
14.5 SETUP SECTION
The SETUP section is the most important area for the configuration of the PhoneX D1. From this
section it is possible to configure all the operating modes of the Hybrids 1 (and Hybrids 2 in case
of a PhoneX D2). The SETUP section is divided into four sub-menus:
1. Hybrid 1
2. Hybrid 2 (only for PhoneX D2)
3. Outputs
4. Program Settings
