Deploying Avaya IP Office™ Platform IP500 V2
Page 157
15-601042 Issue 30j (18 May 2015)
IP Office™ Platform 9.1
Comments on this document? [email protected]
Additional Processes: Defaulting Security Settings
12.7.3 Defaulting Security using the RS232 Port
Read and note the warnings regarding
defaulting the security settings
before using this process.
·
WARNING
Use of the RS232 port should only be performed if absolutely necessary and only if the actions cannot be
completed using IP Office Manager or IP Office Web Manager. In all cases, you must make every effort to ensure
that you have a backup copy of the system configuration.
To default a system' security settings via DTE
This process defaults the IP Office's security settings but does not alter its configuration settings.
1. Attach the serial cable between the PC and the DTE port on the IP Office control unit.
2. Start the terminal program on your PC. Ensure that it has been setup as listed in
DTE Port Settings
. Within a
HyperTerminal session, the current settings are summarized across the base of the screen.
3. Enter AT (note upper case). The control unit should respond OK.
4. Enter AT-SECURITYRESETALL.
5. You will be prompted to confirm the control unit's MAC address before continuing. Enter the address.
6. After approximately a minute, the control unit will respond OK when the action has been completed.
7. Close the terminal program session.
8. IP Office Manager can now be used to receive and edit the control unit's now defaulted security settings.
155
360