© 2009 Austin Kontore LLC
Page 33 of 54
Once the upper prefab square is in place, the unit will look like
this. The upper Core Square is sitting on top of the top Fixed
Panel Units.
Goal:
The upper Core Square should sit flush with the four
posts. It doesn’t have to be exact, but if it is off, the posts
should be slightly lower than the top edge of the Core Square.
Optional:
Prior to pre-drilling, use a clamp to hold Post to the
corner of the Core Square.
Note:
Clamping helps to keep the joint tight. The Posts may
have a tendency to bow inwards while you are working on the
top portion of the coop.
Drill a hole about ¾” from the top of the Middle Square. The
hole should be approximately 1 ½” deep and go through the
Core and into the Post.
Important:
Hold the pieces tightly while drilling. And keep
a level visible, so you can ensure that the piece is level.
Fasten the Post to the corner of the Core Square with one 1
5/8” screw.
Note:
The first corner of the Upper Core Square is now
secured and ready for more drilling and fastening.
REPEAT
this process for the remaining
three
screws on this
corner. Remember to stagger screws on each side of the
corner.
Rotate coop to the next corner and
REPEAT
the above
process for the
remaining
three corners
of the coop.
Note: First fasten the corner with one screw, then drill and
fasten with the remaining three screws. Having the one screw
in place makes drilling the other holes easier.
