© 2009 Austin Kontore LLC
Page 30 of 54
Now that the Middle Core Square has been secured, the two
17” Fixed Screen units will be permanently attached to the core
of the coop.
Note:
These are the two Screens which are clamped (as a
spacer). Now that everything is level and fastened, it is safe to
permanently fasten them to the frame.
Important:
Make sure that the finished side is facing
outwards. The side with the staples should be facing inside.
Confirm that the fixed frame edge is not flush with the Post, but
slightly (about ¼”) inside. This gives the doors room to slide on
their guide rails without bumping into the fixed frame.
Goal:
Center the Fixed Units so that they are centered on
the two Posts. Do not allow them to “stick out” and potentially
affect the sliding doors.
Measure 4” from the top and about ¼” from the side edge of
the upper right corner of the 17” Fixed Screen.
Drill a hole approximately 1 ½” deep –enough to go thorough
the Fixed Unit and into the Post.
Note:
You may need to move the clamps out of the way, to
give clearance for drilling and fastening.
Measure 4” from the bottom and about ¼” from the side edge
of the lower right corner of the 17” Fixed Screen.
Drill a hole approximately 1 ½” deep.
