AudioCodes MediaPack MP-402, Руководство пользователя

Страница: 68 / 160

MP-40x SIP MediaPack BRI Series
SIP User's Manual 68 Document #: LTRT-53301
Table 6-1: SIP General Parameters
Parameter Description
Prack
[prack-mode [disable |
require | support]]
Defines the PRACK behavior.
ƒ
Disable = 100rel is not supported and not required.
ƒ
Supported = 100rel is added to the supported header (default).
ƒ
Required = 100rel is added to the supported and required header.
Early Media
[[no]earlyMedia]
Enable or disable early media.
ƒ
Enabled = use 183 response
ƒ
Disabled = use 180 alerting response (default).
Session Expires
[sessionExpires <val>]
Each time the timer expires, the session is refreshed using a RE-INVITE.
0 = disabled (default)
Valid range is 10 to 3600 sec.
Min Session Expires
[minSessionExpires <val>]
The value used in the Min-SE header filed.
0 = disabled
Valid range is 10 to 3600 sec.
The default value is 90.
Asserted Identity Mode
[asserted-identity-mode
<none | pAssertedIdentity>
Defines the Asserted Identity Mode.
ƒ
None = system does not use the P-Asserted Identity header
ƒ
PAssertedIdentity
Use rPort
[[no]useRPort]
Defines whether or not to add the rPort value to the
via
headers. This defines the
behavior for symmetric response routing.
Valid options include:
ƒ
Enable
ƒ
Disable
SIP Transport Type
[transport <TCP | UDP>]
Defines if UDP or TCP is used as SIP transport.
Valid options include:
ƒ
UDP (default)
ƒ
TCP
SIP local port
[localPort <num>]
Defines the UDP local port.
Valid range is 1 to 8,000. The default is 5060.
SIP proxy port
[proxyPort <num>]
The SIP stack sends requests to this port.
Valid range is 1 to 32767. The default is 5060.
Note: There is no restriction on the proxy port.
Use Source Number as
Display Name
[manipulation sip-display-
name
[no] copy-from-src]
If enabled, the SIP source name is copied to the display name.
Using CLI
To change the SIP general parameters using CLI:
1. Login to the system.
2. Change to the configuration mode.
3. From the main configuration mode, change to the “gateway sip” mode.
4. Use the commands in square brackets ([]) to change the parameter values.