AudioCodes MediaPack MP-402, Руководство пользователя

Страница: 32 / 160

MP-40x SIP MediaPack BRI Series
SIP User's Manual 32 Document #: LTRT-53301
The initial configuration guides you through the basic, essential settings required to create
a basic call between Unit A (Port 0; Ext # 1000) and Unit B (Port 0; Ext # 2000), by using
either a Proxy Server or the Internal Routing tables.
For each unit, Port 0 is configured as Network Side and connected to an ISDN phone. For
each unit, Port 1 is configured as User Side and connected to the PSTN network.
If, after these initial settings, you want to later connect the MediaPack to a PBX, you can
refer to the PBX configuration procedures described in Section '
666H686H
Connecting the MediaPack
to a PBX ' on page
667H687H
134 .
4.1.1 Connecting MediaPack's LAN Interface to your PC
The procedure below describes how to connect the MediaPack's LAN interface to your PC.
¾
To cable and setup your PC for initial MediaPack access take the
next 3 steps:
1. Disconnect the MediaPack from the network (if connected), and reconnect the LAN
interface (port labeled
LAN ) to your PC's LAN port, using a standard Ethernet straight-
through cable.
2. Change your PC’s IP address and subnet mask to correspond with the MediaPack's
factory default IP address (192.168.2.1) and subnet mask (255.255.255.0), shown in
668H688H
Table 4-1 . The recommended IP address is 192.168.2.2, subnet 255.255.255.0, and
default gateway 192.168.2.1
For details on changing the IP address and subnet mask of your PC, refer to
Windows™ Online Help.
3. Power up the MediaPack (refer to Section '
669H689H
Connecting the Power Source ' on page
670H690H
30 ). Ensure that the Ready LED is lit. After the boot sequence (approximately 60 sec),
verify network connectivity by using the ping command from your PC toward the
MediaPack:
ping 192.168.2.1
In case of a ping request failure, verify the PC's IP configuration is correct and that the
network cables are connected properly. If a failure continues, use the MediaPack's
‘Reset’ button at any time to restore the MediaPack networking parameters to their
factory default values (refer to
'Section
691H
2.1.1.1
692H
Reset Button
671H
' on page
693H
19
672H694H19695H19696H19
).
Figure 4-2: Connecting MediaPack to PC for Initial Configuration