AudioCodes MediaPack MP-402, Руководство пользователя

Страница: 104 / 160

MP-40x SIP MediaPack BRI Series
SIP User's Manual 104 Document #: LTRT-53301
4. To save the changes to the flash memory, refer to Section
1054H
6.9 , ’
1055H
Saving Configuration
Settings on the MediaPack ’ on page
1056H
131 ).
Table 6-18: PPPoE Settings Parameters
Parameter Description
PPPoE Service Defines the PPPoE service name. For most providers, no value is defined.
Username Defines the username that the PPP uses.
Password Defines the password that the PPP uses.
Authentication Mode Specifies the allowed authentication options.
Valid options include:
ƒ
Pap = PPP uses Password Authentication Protocol (PAP) to authenticate
ƒ
Chap = PPP uses Challenge Handshake Authentication Protocol (CHAP)
to authenticate
ƒ
Chap pap = PPP can use PAP or CHAP to authenticate
PPPoE Service Defines the requested PPPoE service.
By default, no service is defined.
A PPPoE Client can request a specific PPPoE service. This is used in case
mulibpe PPPoE Server are present and offer different services. In most
configurations the service filed is empty.
MRU
[mru min <num> max <num>]
Defines the lowest accepted Maximum Receive unit (MRU).
During PPPoE link negotiation, the two peers can announce an MRU defining
the largest packet they can accept in one piece. If the peer announces an MRU
lower than this value, the gateway doesn't establish the link. .
The valid range is 68 to 1,500 bytes. The default is 68.
LCP Echo Request Interval
[lcp-echo-request interval
<num> max <num>]]
Defines the interval (in msec) for sending Link Control Protocol (LCP) Echo
requests.
The valid range is 500 to 10,000. The default is 1,500 msec.
Note: LCP echo requests are sent only if no packets are received.
Maximum LCP Echo Requests
[lcp-echo-request interval
<num> max <num>]
Defines the maximum number of unanswered LCP echo requests. This counter
is reset every time an echo request is answered. If the maximum of
unanswered LCP echo requests is reached, the PPP and PPPoE is terminated
and re-established.
The valid range is 1 to 100. The default is 5.
Changing PPPoE parameters using CLI
To change the PPPoE parameters using the CLI:
ƒ
Log on to the system.
To set user, password and authentication mode:
1. From the main configuration mode, change to the “ip_interface” mode. To enter the “ip_interface” mode, use
the command “ip_interface WAN”.
2. Use the command “pppoe user <name> secret <secret> authmode <pap | chap | chap pap>”
To set user and service:
1. From the main configuration mode, change to the “port ethernet” mode. To enter the “port ethernet” mode,
use the command “port ethernet 0 1”.
2. From the “port ethernet” mode, change to the pppoe mode. To enter pppoe mode use the command “pppoe”.
3. From the “pppoe” mode, change to the “pppoe session” mode. To enter the “pppoe session” mode, use the
command “session ppp <name>”. The name must be set to “ppp_WAN”.
4. Define the service using the command “service <name>”
To change PPP parameters:
1. From the main configuration mode Change to the “profile ppp” mode.
2. To enter the “profile ppp” mode use the command “profile ppp default”.