Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4
Rear Lid Roadster
⇒ “2.4.1 Rear Lid“, page 59
⇒ “2.4.2 Stop Buffer“, page 60
⇒ “2.4.3 Rear Lid Hinge“, page 61
⇒ “2.4.4 Gas-filled Strut“, page 61
⇒ “2.4.5 Rear Lid Latch“, page 64
⇒ “2.4.6 Rear Lid Lock Emergency Release Cable“, page 65
⇒ “2.4.7 Rear Lid Seal“, page 67
2.4.1
Rear Lid
1 - Rear lid
• A second person is needed
during removal and instal‐
lation to support and hold
the rear lid.
❑ Removing
– Remove the rear lid trim
panel. Refer to ⇒ Body
Interior; Rep. Gr. 70 ;
Removal and Installa‐
tion .
– Disconnect the electri‐
cal wires and remove
from the lid.
– Remove left and right
gas-filled struts. Refer to
.
– Remove the bolts at the
connection for the rear
lid hinge/rear lid, refer to
– Remove the rear lid.
❑ Installation: in reverse
order.
❑ Adjusting:
• The gas damper must be
attached before installing a
new rear lid.
– Perform height and
length adjustments for
the upper rear lid above
the rear lid hinge.
– Perform lower height adjustment over lid lock.
– Align the lid so it is centered according to the gap dimensions
.
❑ Rear Lid Seal, Removing and Installing, refer to
⇒ “2.4.7 Rear Lid Seal“, page 67
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
59
