Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.1.5
Rear Window
Caution
Insert a plastic washer at the outlet point of the cutting wire as
protection against paint damage, for example.
– Gradually push a cutting wire through the adhesive bead from
the inside to the outside with needle-nose pliers as shown.
– Route cutting wire around rear window under the glass as
shown in the illustration.
– Loosen the hex bolt -arrow- on the rear lid hinge -1- and clamp
the end of cutting wire-2- securely with it.
– Clamp the cutting wire in the spool.
– After removing window, tighten bolt to 21 Nm.
– Cut first area free.
– Move spooling tool as shown and position idler pulley on lower
part of window.
• Wire run according to figure.
– Cut window free until the cutting wire is no longer fed through
the idler pulley.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
207
