Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Clean all surfaces -arrows- that will later be in contact with
double-sided adhesive tape with cleaning solution -D 009 401
04- .
– Adhere double-sided adhesive tape -1- and -3- to the outside
of attachment surface-2- on the left and right as shown in the
figure.
– Screw in the hex socket screws with the dimensions -a- and
-b- as centering pins in the 3 center mounting holes of the
spoiler upper part.
• Dimension -a- = approximately 9.8 mm
• Dimension -b- = 5.5 mm.
– Place the spoiler center part on a soft clean surface on the
workbench.
– Remove the protective films on the contact surfaces for the
base plate.
– Roughen the contact surfaces for the base plate with sandpa‐
per and clean with cleaning solution -D 009 401 04- .
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
3. Removal and Installation
243
