Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Door window
❑ Removing
– Door trim removed. Re‐
fer to ⇒ Body Interior;
Rep. Gr. 70 ; Removal
and INnstallation .
– Front and rear inner
door plate cover or
speaker removed
– Run window down until
bolts -2- and -5- in door
opening are accessible
– Remove bolt -6-, only
loosen bolt -2-.
– Tip window forward and
remove it upward from
window shaft.
❑ Installing:
– Insert in window regula‐
tor in reverse sequence.
❑ Press window back into
window guide and tight‐
en bolts -2- and -6-
slightly.
– Run window up into
door seal, this centers
the window in the door
opening.
– Using Suction Lifter -
V.A.G 1344- , press win‐
dow up into seal on roof
and forward into seal on
»A-pillar« and hold in this position.
– A second technician must tighten bolts -2- and -6- to the specification from inside of vehicle.
– Perform height or side adjustment if necessary. Refer to
⇒ “1.2.1 Door Window, Adjusting“, page 193
2 - Front bolt
❑ 7 Nm
3 - Nut
❑ 9 Nm
4 - Front clamping brackets
5 - Window regulator
❑ Removing and installing, refer to
⇒ “2.2.1 Window Regulator“, page 87
6 - Rear bolt
❑ 7 Nm
7 - Thrust piece
❑ No replacement part
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
213
