Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Spoiler
❑ Removing
– Extend spoiler
– Remove bolts -4- and
remove spoiler.
❑
Installing:
Note
– The read lid trim panel is
removed. Refer to ⇒
Body Interior; Rep. Gr.
70 ; Removal and Instal‐
lation
– Retract spoiler.
– Remove water drain ho‐
ses.
– Clip adjusting elements
into spoiler
– Align intermediate piece
according to adjusting
elements and bond to
spoiler.
– Insert spoiler in drive
unit and align slides, top
and bottom.
– With assistants, press
spoiler in evenly and
hold firmly.
– Open lid and tighten bolts -4- through water drain hose opening.
– Install water drain hose, ensuring it is seated correctly and does not leak.
2 - Adjusting element
❑ Always replace.
❑ Clip into spoiler
❑ The adjusting elements are self-adjusting. That means height differences can be evened out by the
adjusting elements.
3 - Intermediate piece
❑ Self-adhesive
4 - Bolt
❑ Always replace.
❑ 6 Nm
5 - Spoiler motor
❑ Removing
– Rear lid trim removed. Refer to ⇒ Body Interior; Rep. Gr. 70 ; Removal and Installation .
– Remove water drain hoses.
– Disconnect electrical connectors.
– Remove nuts -8- and remove motor from lid.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
238
Rep. Gr.66 - Exterior Equipment
