Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.3
Rear Lid - Coupe
⇒ “2.3.1 Rear Lid“, page 50
⇒ “2.3.2 Rear Lid Stop Buffer“, page 51
⇒ “2.3.3 Rear Lid Hinge“, page 52
⇒ “2.3.4 Rear Lid Hinge Cover“, page 53
⇒ “2.3.5 Gas-Filled Strut“, page 53
⇒ “2.3.6 Rear Lid Latch“, page 56
⇒ “2.3.7 Rear Lid Seal“, page 58
2.3.1
Rear Lid
1 - Rear lid
• A second person is needed
during removal and instal‐
lation to support and hold
the rear lid.
❑ Removing
– Remove the rear lid trim
panel. Refer to ⇒ Body
Interior; Rep. Gr. 70 ;
Removal and Installa‐
tion .
– Disconnect the electri‐
cal wires and remove
from the lid.
– Remove left and right
gas-filled struts. Refer to
– Remove the bolts at the
connection for the rear
lid hinge/rear lid, refer to
.
– Remove the rear lid.
❑ Installation: in reverse
order.
❑ Adjusting:
• The gas damper must be
attached before installing a
new rear lid.
– Perform height and
length adjustments for
the upper rear lid above
the rear lid hinge.
– Perform lower height adjustment over lid lock.
– Align the lid so it is centered according to the gap dimensions
.
– Adjust stop buffers
❑ Rear Lid Seal, Removing and Installing, refer to
⇒ “2.3.7 Rear Lid Seal“, page 58
.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
50
Rep. Gr.55 - Hood, Lids
