Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Replace spool as shown and position idler puller in upper part
of window.
• Route cord as shown.
– Slide Cover for Dash Panel -V.A.G 1474/7- between wind‐
shield and headliner.
– Cut window free until cutting cord is no longer fed through idler
pulley.
– Remove idler pulley and continue cutting window free.
– Repeat procedure in upper and lower left parts of windshield.
– Cut glass completely free in this manner.
– Remove windshield from windshield opening using suction
lifter.
Preparations for Installing Windshield
– When reusing the undamaged window, cut rest of adhesive
material on window and flange with -V.A.G 1561 A- and -V.A.G
1561/8- so it is even, but do not remove completely.
Note
Residual material acts as a base for the new adhesive sealing
material.
Caution
♦ Keep adhesive surface free of dirt and grease.
♦ Only cut back adhesive surface shortly before installation.
♦ Do not prime or use a cleaning solution on the adhesive
surface.
With New Window:
– Clean window all around in adhesive area using Cleaning Sol‐
ution -D 009 401 04- .
– Apply Glass and Paint Primer -D 009 200 02- as described
below.
Caution
Ceramic application on window is not primer! It must be primed
before the application of adhesive sealing material!
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
200
Rep. Gr.64 - Glass, Window Regulators
