Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Adhesion surfaces must be free of dust and grease, clean with cleaning solution D 009 401 04 -Reini‐
gungslösung- .
– Place the door seal in the vehicle following the contour.
– Remove the protective films from the double-sided adhesive tape and press it onto the »B-pillar« on the
left and right.
– Press the door seal on the »B-pillar down onto the body flange«
– Slide the door seal onto the »A-pillar« on the front seal.
Caution
The door seal must be
installed without a gap at
the junction to the front
seal.
– Press the door seal in the lower radii areas onto the flange while distributing any excess length in the sill
area.
– Align the molded pieces of the door seal on the »upper B-pillar« with respect to the side piece and install.
– Press the door seal on both sides backward in the convertible top compartment onto the body flange.
3 - Water tray
❑ Attach the door seal to the water tray as shown in the magnified area of the illustration -arrow-.
Replacing Outer Door Seal
Note
♦
The door outer seal is completely bonded and can only be replaced.
♦
Adhesion surfaces must be free of dust and grease.
♦
Both the vehicle and the seal must be room temperature.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
84
Rep. Gr.57 - Front Doors, Central Locking System
