ATTO Technology FastStream NDMP 4600, Инструкция по установке и эксплуатации

Страница: 41 / 58

34
Interfaces: CLI
SCSIPortReset
Resets the specified SCSI bus.
SCSIPortReset [sb]
SNTP
Controls the SNTP (Simple Network Time Protocol)
settings for the FastStream NDMP 4600. When enabled,
the FastStream NDMP 4600 tries to contact a specified
SNTP server at reset and every 12 hours after to
initialize/synchronize the time.
Default: Enabled
set SNTP [enabled|disabled]
Requires a SaveConfiguration command
get SNTP
SNTPServer
Controls the IP address of the SNTP time server that the
FastStream NDMP 4600 contacts to
initialize/synchronize the time.
If the FastStream NDMP 4600 is unable to contact the
specified SNTP server within 30 seconds, the FastStream
NDMP 4600 tries to contact the first auxiliary SNTP time
server. If the first auxiliary SNTP time server is not
available, the FastStream NDMP 4600 tries to contact
the second auxiliary SNTP time server. If the second
auxiliary SNTP time server is not available, the
FastStream NDMP 4600 continues to approximate the
time based on the most recent SNTP time server, physical
real time clock or manual initialization/synchronization.
Alternative auxiliary time servers
129.6.15.28 (
www.time-a.nist.gov
)
132.163.4.101 (
www.time-a-timefreq.bidrdoc.gov
)
Default: 192.43.244.18 (
www.time.nist.gov
)
set SNTPServer [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration command
get SNTPServer
Time
Controls the time for the FastStream NDMP 4600 if
SNTP has been disabled or is not available.
set Time [HH]: [MM]: [SS]
Requires a SaveConfiguration command
get Time
TimeZone
Controls the time zone for the FastStream NDMP 4600 if
SNTP has been disabled or is not available. Choices are
EST, CST, MST,
.
PST or numerical offset from GMT in the
form of +/-:HH:MM.When SNTP is enabled, the
FastStream NDMP 4600 applies the time zone setting to
the time retrieved from a specified SNTP time server to
determine local time.
Default: EST
set TimeZone [ [EST | CST | MST | PST] [+ / - HH :MM ] ]
Requires a SaveConfiguration command
get TimeZone
Username
Specifies user name for all TCP/IP, FTP and
ExpressNAV web server sessions.The user name is case
insensitive, 1-32 characters, no spaces. Changes to the
Admin Level User name require an Admin Level
password.
Default: root
set Username [user name]
Requires a SaveConfiguration command
get Username