ATTO Technology FastStream NDMP 4600, Инструкция по установке и эксплуатации

Страница: 17 / 58

10
Remote management
Exhibit 2.2-1 The E-mail messages sent by the FastStream NDMP 4600 follow this format.
Subject: [The Type of Event that Occurred]
Message Body:
This is a status message from [BridgeName]. Identifying information as well as
the most recent entries from the event log appear below.
*************** Unit Information ***************
Serial Number : [Serial Number]
IP Addresses: [IP Address1]
[IP Address2]
etc…
*************** Event Log Entries ****************
[Listing of the ten latest event log entries]
Simple Network Management Protocol (SNMP)
Remote system monitoring is also available using
Simple Network Management Protocol (SNMP). An
agent resides in the FastStream NDMP 4600 which
takes information from the FastStream NDMP 4600
and translates it into a form compatible with SNMP. If
certain conditions arise, the agent sends notifications
(traps) to a client.
Refer to
Diagnostic commands on page 29 for
detailed information on the commands which regulate
SNMP on the FastStream NDMP 4600.
Contact your network administrator for the MIB
software and appropriate MIB file for your FastStream
NDMP 4600.
Use the
Remote Management page of the
ExpressNAV interface to enable traps or extended
traps, to designate the trap recipient IP addresses, and
to indicate the severity level.
Setting up SNMP
1 If you are not already in the ExpressNAV GUI,
type the IP address of your FastStream NDMP
4600, as found in
Discover the IP address on
page 5, in a standard browser and press Enter .
2 In the left-hand menu, click on the Remote
Management page.
3 Click on the enable button in the Traps or
Extended Traps line.
4 Enter the Trap Recipient IP addresses .
5 From the drop-down box next to each trap
address, select the level of severity for which
you want each address to be notified.
6 Press Submit.
After rebooting, the FastStream NDMP 4600
sends notifications as you set them up.