ATTO Technology FastStream NDMP 4600, Инструкция по установке и эксплуатации

Страница: 20 / 58

13
ATTO Technology Inc. FastStream Installation and Operation Manual
3 Updating firmware
Several processors control the flow of data in the ATTO FastStream NDMP 4600. The firmware to
control these processors can easily be upgraded in the field using the ATTO ExpressNAV interface or
the
PUT command from an FTP connection. The ATTO ExpressNAV method is preferred.
Preliminary steps
1 The FastStream NDMP 4600 firmware is
distributed as a compressed .zip file and can be
obtained from the ATTO Technology, Inc. web
site at
www.attotech.com
or from the CD
included with your FastStream NDMP 4600.
2 Uncompress the .zip file into an image file
( .ima ). Note the filename.
CAUTION CAUTION
Before beginning this procedure, ensure
that all I/O to the FastStream NDMP 4600
has stopped.
During this procedure , do not interrupt the
flash process.
Do not power down the host or the
FastStream NDMP 4600 until the display
returns the Ready prompt.
Interrupting the flash process will make
your FastStream NDMP 4600 inoperable
and you will have to return it to ATTO
Technology for repair.
Note
The recommended management tool for the
FastStream NDMP 4600 is ATTO
ExpressNAV.
Using ATTO ExpressNAV
1 If you are not already in the ExpressNAV GUI,
type the IP address of your FastStream NDMP
4600, as found in
Discover the IP address on
page 5, in a standard browser and press Enter .
2 From the left-hand menu, click on the
Firmware page.
3 Click Browse and locate the firmware you
unzipped in the preliminary steps.
4 Click Upload and wait until a success message
is displayed.
5 Click the Restart link.
6 Click on Restart .
Using FTP over GbE
1 Establish an FTP link to the FastStream NDMP
4600.
2 Use the PUT command to upload the firmware
you unzipped in the preliminary steps. For
example
c:\bridge_firmware\ndmp0371.ima
3 Once the upload is complete, cycle power on
the FastStream NDMP 4600 using the
FirmwareRestart CLI command.