ATTO Technology FastStream NDMP 4600, Инструкция по установке и эксплуатации

Страница: 25 / 58

18
Browser-based GUI
• Set the NDMP authorization type and NDMP
Max Version and NDMP port number for each
data port
Refer to Maintenance commands on page 33 and
NDMP commands on page 41.
Firmware
You may update firmware using ExpressNAV.
Refer to
Updating firmware on page 13.
Advanced
Allows you to input CLI commands. See
Exhibit 4.1-1 for an example.
1 Type in the CLI command
2 Click the Submit button.
3 A text field beneath the box lists the most recent
commands issued to the FastStream NDMP
4600 through this page.
4 If you enter an incorrect parameter, the CLI
help text is displayed, showing the parameters
available.
5 If your entry was correct, type
saveconfiguration
6 Click the Submit button. Your changes are
implemented.
Restart
Implements a firmware restart of the FastStream
NDMP 4600 and makes permanent any changes
you have made since the last firmware restart.
1 Click the Restart button.
A box tells you to wait until the counter gets to
0 and then the browser refreshes.
2 If the browser does not refresh after the counter
gets to 0, click the link to refresh it manually.
Note
Restarting the firmware may take a few
minutes.
Help
Gives help information about the command line
interface commands and troubleshooting tips via
links to pages with help text for each category of
options and one link to the Troubleshooting Tips
and FAQs page on the ATTO website,
www.attotech.com
, or from the CD included with
your FastStream NDMP 4600.
Contact information for ATTO technical support
is on the right.
Help is always available by pressing any word
shown in red on the screen
Exhibit 4.1-1 Command and response sequence in the CLI Advanced Configuration page.
Ready prompt
Command input
Error message
Help text
Correct input
Response