ATTO Technology FastStream NDMP 4600, Инструкция по установке и эксплуатации

Страница: 12 / 58

5
ATTO Technology Inc. FastStream Installation and Operation Manual
2 Installing the FastStream NDMP 4600
If you have not already completed the instructions on the Quick Start page packed with your ATTO
FastStream NDMP 4600, use the following instructions to install the FastStream NDMP 4600.
Unpack the packing box; verify contents
• The FastStream NDMP 4600. Note the serial
number of your unit, located on the bottom of the
unit, for later use: _______________________
• Serial cable
• Power cord
• “L” brackets and screws
• CD which includes the Installation and Operation
Manual and ATTO QuickNAV
Place the FastStream NDMP 4600 into
your system
1 Place the FastStream NDMP 4600 on a stable
flat surface or install it into a standard rack.
If installing into a rack, see Exhibit 2.0-1.
a. Attach “L” brackets so that the front side
with the LEDs face front and the connector
side is at the back.
b. Install the FastStream NDMP 4600
horizontally within the rack so it does not
reduce the air flow within the rack.
2 Connect and power up SCSI target devices.
3 Connect the FastStream NDMP 4600 Ethernet
port to your network using at least Cat5e cable.
4 Connect the AC power cord from the
FastStream NDMP 4600 to the proper AC
source outlet.
If you are using a rack:
a. Properly ground the FastStream NDMP
4600 to the rack equipment. The earth
ground connection must be maintained.
b. The power requirements plus the power
draw of the other equipment in the rack
must not overload the supply circuit and/or
wiring of the rack.
5 Turn on the power switch on the FastStream
NDMP 4600.
6 Wait up to two minutes for the FastStream
NDMP 4600 Ready LED to light indicating the
unit has completed its power-on self test
sequence.
Discover the IP address
1 From the CD supplied with your FastStream
NDMP 4600, run the QuickNav Utility
QuickNAV-windows.exe for Windows or
QuickNAV-Mac for Mac OS X.
2 Locate the FastStream NDMP 4600 with the
serial number recorded earlier.
3 Highlight the serial number.
4 Click Next .
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an
IPaddress and subnet mask from your network
administrator, type it into the area provided, and
select
Next . Note the IPAddress and subnet
mask here.
____________________________________
____________________________________
5 Click on Launch Browser
Begin initial configuration
1 The ExpressNAV welcome screen appears.
Click on
Enter Here
2 Enter the user name and password.
Note
The default user name is root; it is case
insensitive. The default password is
Password ; it is case sensitive. It is best
practice to change the passwords. Refer to
Additional configurations on page 11.
3 Use the ExpressNAV browser-based interface
to name and map NDMP. Refer to
ATTO
ExpressNAV interface on page 15 for
information on ExpressNAV, and refer to
Setting up NDMP on page 7 for information on
mapping.