ATTO Technology FastStream NDMP 4600, Инструкция по установке и эксплуатации

Страница: 36 / 58

29
ATTO Technology Inc. FastStream Installation and Operation Manual
5.1.3 Diagnostic commands
ATTO FastStream NDMP 4600 diagnostic commands help validate FastStream NDMP 4600 operation
and diagnose/isolate FastStream NDMP 4600 faults. Event logging is a mechanism for on-site
observation of internal FastStream NDMP 4600 behavior such as tracing commands received over the
GbE from the host and return of data and status to the host.
BridgeModel
Reports model information about a specific FastStream
NDMP 4600.
get BridgeModel
BridgeName
Specifies name used to identify individual FastStream
NDMP 4600 units. May be up to a maximum of eight
characters. It is not the World Wide Name (WWN).
default: UnitDflt
set BridgeName [name]
Requires a SaveConfiguration command
get BridgeName
ClearEventLog
Clears the contents of the event log. No events are
recorded until the command has been completed.
ClearEventLog
ClearTraceLog
Clears the contents of the trace log. No events are
recorded until the command has been completed.
ClearTraceLog
DisplayEventLog
Displays the most recent page of event log entries. Typing
a +, - or = causes the next, previous or same page of event
log entries to be displayed. No events are recorded until
the command has been completed. Type <escape> to
disable the command, begin new log entries, and return
to CLI.
DisplayEventLog
DisplayEventLogFilter
Filters the display of data using the DumpEventLog
command for specific FastStream NDMP 4600
subsystems when in
DisplayEventLog mode. If enabled
for a particular subsystem and level, that subsystem and
level are masked when the command
DisplayEventLog
is issued.
Default: disabled
set DisplayEventLogFilter [subsystem] [level]
get DisplayEventLogFilter [subsystem] [level]
DisplayTraceLog
Displays the most recent page of trace log entries. Typing
a +, - or = causes the next, previous or same page of trace
log entries to be displayed. No events are recorded until
the command has been completed. Type <escape> to
disable the command, begin new log entries, and return
to CLI.
DisplayTraceLog
DisplayTraceLogFilter
Filters the display of data using the DumpTraceLog
command for specific ports when in DisplayTraceLog
mode. If all is set for a particular port, all information
about that port are captured when the command
DisplayTraceLog is issued. If disabled is set for a port,
no trace log entries for the port are displayed.
Default: all all all
set DisplayTraceLogFilter [scsi| all] [sb | all] [chkcond | all]
get DisplayTraceLogFilter [scsi | all] [sb | all]
DumpConfiguration
Displays a unit’s configuration to an RS-232 or TCP/IP
session (over Ethernet) without impact on the log itself.
(the log is not cleared). No events are recorded until the
command has been completed.
DumpConfiguration