Asco Froment 8800 Series, Руководство пользователя

Страница: 44 / 114

Chapter Three
3 - 2
Before Operating the Load Bank
Ensure that:
•
The load bank has been installed according to the instructions and safety warnings in
Chapter Two.
•
The external supply (for fans and controls) is connected according to the instructions
in Chapter Two.
•
The supply under test is connected according to the instructions in Chapter Two.
Safety warning
Do not attempt to operate the load until you have read and understood this manual. Misuse
could result in serious injury and damage to the equipment.
•
Keep all personnel who are not directly involved with testing the supply well away from
the load bank and from the equipment under test.
•
The discharge air can be very hot and can cause serious burns. Do not touch the outlet
grille while the load bank is running, or for a few minutes afterwards.
•
Only operate the load bank with all the guards in place, with doors closed and with all
of the covers and protective screens securely in position.
•
Ensure that there is no risk of the hot discharge air re-circulating back to the air inlet
of the load bank, extensive damage is possible due to re-circulating the cooling air.
•
Ensure that there is no loose paper, plastic bags, or other debris that could be drawn
in to the air inlet, or any combustible material left within range of the air discharge.
•
After removing the load at the end of a test allow the fan to run for five minutes to
dissipate the residual heat.
•
HV testing must be done be qualified personnel and local rules and regulations must
be taken into account.