Arctic Cat DVX 90/90 UTILITY, Руководство по обслуживанию

Страница: 83 / 86

80
MD2007
5. Install the washer and self-locking nut. Tighten the
nut to 50 ft-lb.
6. Install the axle, spacers, hubs, and drive chain (see
the Drive System section).
7. Secure the shock absorber to the swing arm with the
cap screw. Tighten the cap screw to 29 ft-lb.
MD2315
8. Place the rear chain guard and skid plate into posi-
tion and install the cap screws; then tighten the cap
screws securely.
MD2014
9. Place the axle housing into position on the swing arm;
then install and tighten four cap screws to 29 ft-lb.
10. Install the brake caliper on the axle housing with the
two cap screws. Tighten securely.
KM229
11. Install the wheels and tighten the cap screws to 30 ft-
lb; then remove the ATV from the support stand.
Wheels and Tires
TIRE SIZE
The ATV is equipped with low-pressure tubeless tires of
the size and type listed (see General Information - Gen-
eral Specifications). Do not under any circumstances
substitute tires of a different type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.21 kg-
cm
2
(3.0 psi).
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
2. Remove the four cap screws securing each wheel;
then remove the wheels.

NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
CAUTION
Do not tighten the cap screw beyond the 29 ft-lb specifi-
cation or the shock eyelet or mount WILL be damaged.
! WARNING
After removing and installing of brake-related compo-
nents, ALWAYS check and adjust brakes as necessary
before operating the ATV.
! WARNING
Use only Arctic Cat approved tires when replacing tires.
Failure to do so could result in unstable ATV operation.
! WARNING
Do not mix tire tread patterns. Use the same pattern type
on front and rear. Failure to heed warning could cause
poor handling qualities of the ATV and could cause
excessive drive train damage not covered by warranty.
! WARNING
Always maintain proper tire inflation pressure.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.