Arctic Cat DVX 90/90 UTILITY, Руководство по обслуживанию

Страница: 59 / 86

56
5. Install the float and needle valve assembly into the
carburetor; then install the float pin.
CD763

NOTE: Check float arm height by inverting the car-
buretor freeing the float arm; then measure with a
ruler the height when the float arm is in contact with
the needle valve. Float arm height should be 10.2 mm
(0.40 in.). To adjust, bend the actuator arm tab.
CD615
6. Install the float chamber seal.
CD601
7. Place the float chamber into position making sure the
seal is properly seated; then secure with the Phillips-
head screws and washers.
CD600
8. Install the choke assembly. Tighten the two Phillips-
head screws (with washers) securely.
CD598
9. Insert the throttle cable into the top of the cap assem-
bly and through the spring.
10. Compress the spring to expose the end of the throttle
cable; then hook the end of the cable into the throttle
valve. Release tension on the spring to hold the throt-
tle cable.
INSTALLING
1. Install the throttle valve into the carburetor with the
machined groove engaging the guide pin; then install
the jet needle, needle clip, needle clip plate, and gas-
ket.
2. Thread the carburetor cap onto the carburetor; then
tighten securely.
CD594
3. Connect the choke assembly connector.