VP5000-DC/DC60, VP5000-DC/DC200-HL
Installation and commissioning
Last edited 2019-02-08
by Sonja Scheunert
Filename
VP5000_DCDC60_200-HL_installation_manual_v1-4en.docx
138 / 173
i
Note on malfunctions
For each individual application, a parameter set (I/Os with values) and, if required, modules (to
extend the functionality) are created in VE. These are specially adapted to a VE version.
If the VE version is changed, the modules are not executed correctly and the I/Os are not called
or stored correctly. These problems usually occur when VE is started. In very rare cases,
malfunctions may occur during operation.
•
Use the VE version for which the parameter set and the modules were created.
•
Note the version of the software (VE, VEConfig, parameter set, modules, higher-level control)
with which the initial commissioning was carried out. Make a backup copy of the files and
software with which the initial commissioning was carried out. Do the same for updates.
•
Observe the compatibility in the case of future updates.
6.4.4
Initial commissioning with an existing parameter set
Information:
If this is an initial commissioning for a new application for which ARADEX AG has created a
parameter set, this procedure is recommended.
If the commissioning is for a series application, an existing parameter set is transferred to another
device. The procedure is somewhat different from the one described here. See chapter 6.4.5
Installation and commissioning, Commissioning, Commissioning for a series application.
This manual describes commissioning with VEConfig via CAN bus. Commissioning with other
software and via other interfaces is also possible.
The supplied parameter set is a set of values that have been carefully determined by ARADEX AG.
These must be checked and adapted to the actual conditions of your application. To optimize your
application, refer to the VE operating manual.
VE is pre-installed on the delivered device. The parameter set (and, if required, the modules for
extending the functionality) are created specifically for a VE version. If the VE version pre-installed
on the device differs from the version for the parameter set (and modules), contact the developer
of your application. Either a different VE version must be installed or the parameter set (and the
modules) must be adapted to the pre-installed VE version.
If VE, the parameter set (and the modules) have different versions, the modules do not run
correctly and the I/Os are not called or stored correctly. These problems usually occur when VE is
started. In very rare cases, malfunctions may occur during operation.
Prerequisites:
•
The system is set up.
