AMX modero NXD-CV10, Руководство по эксплуатации/справочник

Страница: 37 / 208

CV10 Touch Panel Accessories
25 10" Modero Touch Panels
4.
Gently slide the connector overlay away from the back box housing.
5.
Unscrew the outer housing (back box) by using a grounded Phillips-head screwdriver to remove the two
sets of pan-head Housing Screws, located on both sides of the housing (FIG. 24).
6.
Carefully lift-off the back box housing and angle it over to the side of the unit where the wires are
connected to the circuit board.
7.
Gently lay the back box to one side of the unit. This exposes the internal circuit board (FIG. 25). Take
care not to place undue strain on the speaker cables.
Step 2: Install the new Compact Flash Memory card (NXD)
Complete the procedures outline within Step 2: Install the Compact Flash Memory card upgrade section on
page 22 and then continue with the following Step 3.
Step 3: Install the new 802.11g Wireless Compact Flash card (NXD)
Complete the procedures outline within Step 3: Install the new 802.11g CF Card and Antenna section on
page 23 and then continue with the following Step 4.
Step 4: Close and Resecure the NXD Panel Enclosure
1.
Gently place the outer housing back onto the panel and align the four pan-head Housing Screws holes
along the edges of the outer housing.
2.
Insert and secure the four pan-head Housing Screws back into their pre-drilled holes by using a grounded
Phillips-head screwdriver.
3.
Slip the connector overlay back into the connector opening by inserting the top of the overlay into the
connector opening in an upwards direction.
4.
Align the connectors to their respective locations and secure the overlay by pushing it towards the
connectors until the overlay securely snaps back into the overlay release latches.
5.
Re-install the faceplate back onto the panel. Refer to the Installing the No-Button Trim Ring section on
page 33 for more detailed faceplate installation information.
The overlay connector must first be released before the rear back box can be
removed from the NXD-CV7 panel.
FIG. 25 Location of the wireless CF card connector on main board
Caution: Speaker wires come connected
to this side of the main board.
Use caution when removing
the back box.
Connector overlay must first be
removed from the side of the NXD
Wireless CF card (Slot #2
is located on the top slot)
The circuit board comes pre-wired to internal speakers located on the inside surface
of the rear back box. If the back box is removed incorrectly, these speaker wires can
become disconnected and damaged.