AMX Modero NXD-CA12, Руководство по эксплуатации/справочник

Страница: 74 / 168

Configuring Communication
64 12” and 15” Modero Touch Panels
2.
Verify that the NetLinx Master is receiving power and is communicating via an Ethernet connection with
the PC running NetLinx Studio.
3.
Connect the terminal end of the PSN power cable to the 12 VDC power connector on the
rear/side of the touch panel.
4.
Verify the green Ethernet LED (from the rear Ethernet port on the Master) is illuminated (indicating a
proper connection).
5.
Verify the yellow LED (from the rear Ethernet port on the Master) is blinking (indicating
communication).
6.
After the panel powers-up, press and hold the grey Front Setup Access button ( for 3 seconds ) to proceed
to the Setup page.
7.
Select Protected Setup > System Connection (located on the lower-left) to open the System Connection
page (FIG. 62).
Master Connection - Virtual Master communication over Ethernet
Before beginning:
1.
Verify the panel has been configured to communicate either through an Ethernet cable (connected from
either the panel to a valid Ethernet Hub) or wireless to the Wireless Access Point.
2.
Launch NetLinx Studio 2.4 (default location is Start > Programs > AMX Control Disc > NetLinx
Studio > NetLinx Studio 2.4 ).
3.
Select Settings > Master Communication Settings , from the Main menu to open the Master
Communication Settings dialog (FIG. 63).
Before commencing, verify you are using the latest NetLinx Master firmware.
FIG. 62 System Connection page
Obtained
from
NetLinx
Master
When configuring your panel to communicate with a Virtual Master (on your PC), the
Master IP/URL field must be configured to match the IP Address of the PC and use
the Virtual System value assigned to the Virtual Master within NetLinx Studio.