AMX Modero NXD-CA12, Руководство по эксплуатации/справочник

Страница: 50 / 168

Installation Procedures: 12" and 15" Panels
40 12” and 15” Modero Touch Panels
Installing the NXD into drywall using Expansion Clips
Expansion clips are mounted through the four oval holes located at the top and bottom of the panel. As the
screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a "grip" on
the wall by either pressing onto the wall or by securing the drywall between the housing and the drywall clip.
The most important thing to remember when mounting the NXD is that the outer frame (Mounting Tabs) must
be installed flush against the mounting surface.
1.
Remove any screws or nails from the drywall before beginning.
2.
Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 40 and for the 15-
inch Wall Mount using the dimensions shown in FIG. 41. Be sure to cut out the four notches along the
top and bottom areas to accommodate the four drywall expansion clips (provided).
3.
Remove the magnetic faceplate/bezel ( A in FIG. 42) from the main NXD unit ( B in FIG. 42) by gripping
the faceplate and pulling with gentle outward force.
4.
Thread the incoming RJ-45, Ethernet, and any other audio/video wiring (from their terminal locations)
through the cutout opening. Refer to the
Wiring Guidelines for the 12" and 15" Panels section on page 47
for pinout descriptions. Leave enough slack in the wiring to accommodate any re-positioning of the panel .
FIG. 40 NXD 12-inch Wall Mount panel dimensions using expansion clips
FRONT BEZEL
CUTOUT