Ametek Thermox Series 2000 WDG-IV, Руководство пользователя

Страница: 164 / 193

Serial Communications
|
A-9
Config_flags
S2
System configuration flags (1=true,
0=false)
bit 0
– auto verify cycle time is
programmed in hours, 0 if in days
bit 1
– Auto cal option is installed
bit 2
– Combust module is installed
bit 3
– Future use
bit 4
– Future use
bit 5
– RTD type combustible detector, 0=
Hot wire detector
bit 6
– WDG type sensor, 0 is HP type
sensor
bit 7
– combustibles are measure in
percent,0 = combustibles are measured in
PPM
bit 8
– relays energize on alarm. If not,
they deenergize.
bit 9
– auto calibration time is set, an
auto calibration will happen at the set
time if the auto calibration is enabled
bit 10
– auto calibration timer is enabled,
since this is enabled, an auto calibration
will occur at the auto calibration time.
(0=true, 1=false)
bit 11
– real time clock is set.
bit 12
– Step Function enabled (only for
RSS)
bit 13
– auto verify time is set, an auto
verify will happen at the set time if the
auto verify is enabled.
bit 14
– auto verify timer is enabled, if
this is enabled an auto verify will occur
at the auto verify time. (0=true, 1=false)
bit 15
– auto calibration cycle is
programmed in hours, 0 if in days
R/W