Alto-Shaam CT Express Combitherm CTX4-10E, Руководство по установке

Страница: 39 / 52

CT Express Checklist
MN-29805 • Rev 11 • 07/18 • Combitherm CT Express Installation Manual 39
Use this list as a final check of appliance installation conformance.
Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims.
Clearances:
Left: 4" (102mm) — 18" (457mm) recommended service access
8" (203mm) from heat or steam producing equipment
Right: 4" (102mm) non-combustible surfaces
Rear: 4" (102mm) for plumbing
Top: 20" (508mm) for air movement
Bottom: 4" (102mm) for air movement
Are all clearance
requirements met?
Yes No
If no, explain: ______________________________________
__________________________________
Water Supply And Drains:
Verify hook up of two (2) cold water lines: treated and untreated water with a 3/4"
(19mm) G inside diameter connection supply line. Verify inlet water pressure is
at a minimum of 30 PSI (200 kPa) dynamic. Maximum water pressure is not to
exceed 90 PSI (600 kPa) static. Minimum flow rate 0.13 gpm (0.5 L/min). Verify
drain diameter of 1-1/2" (50mm) with a positive descending slope, and with a
2" (51mm) air gap which is free of obstructions before connection to the site drain.
Verify 1/8" (3.2mm) pitch to 10' (305cm) of drain line. Materials must withstand
temperatures up to 200°F (93°C).
NOTICE:
Alto-Shaam has listed Water Quality Requirements in the
installation manual for this equipment. It is the responsibility
of the end user to have the water connected to this appliance
tested to ensure these standards are met before putting the
appliance into use. Failure to meet these standards will void the warranty if damage to the appliance is found to
be related to water quality.
Inspect water connections inside the combi.
Check all lines and connections for leaks, both inside and outside the combi.
Are both water supply lines
properly connected?
Yes No
If no, explain: ________________________________
Is a filter system installed
on this appliance?
Yes No
Store has seen this
recommendation:
Yes No
Signature of store representative:
________________________________________________
Physical Condition:
*Reference installation instructions for complete information
✓
Bottom of appliance has been checked for damage due to improper positioning on site ........................................................
Verify all gaskets and hoses are in place and function properly ....................................................................................................
Verify the installation of drip pans*, racks, shelves, drain screen, spray hose* ...........................................................................
Verify the appliance is level and installed on a solid, water resistant surface ..............................................................................
Electrical Connections:
Verify electrical power requirements for appliance.
Verify voltage at terminal block.
Check all terminals for tightness.
Line voltage at terminal block (to ground):
Line 1: __________ Line 2: __________ Line 3: __________
Line voltage (phase to phase): Line 1 to 2: __________
Line 2 to 3: __________
Line 3 to 1: __________
Electrical supply line size: _____________________________
All electrical terminals tight:
Yes No
Voltage:
______________
Phase:
______________
Breaker size:
______________
Control Board Connections & Operation:
ExpressTouch
: With the power on, press the Tool Box
icon, then the Settings icon to access software version in
the upper left corner.
All board connections tight: Yes No
All functions are displayed: Yes No
All functions on control operate: Yes No
Appliance operates in all modes: Yes No
If no, explain: ________________________________________________________________
______________________________________________
RB__________________
Record software version: DB__________________
Service Agency: Start-Up Date:
Installation Name:
Model No.: Serial No.:
Tech Signature: Customer Signature:
CT Express™ Checklist