Alto-Shaam CT Express Combitherm CTX4-10E, Руководство по установке

Страница: 28 / 52

Installation
28 MN-29805 • Rev 11 • 07/18 • Combitherm CT Express Installation Manual
How to install the water drain piping
Requirements
▪
The oven must drain through an indirect waste pipe by means of an air gap
a
.
▪
The drain line
b
must always be a positive gradient away from the appliance.
▪
The drain floor sink
c
should be within 3' (914mm) of the oven.
▪
A union
d
is required. The supplied drain fitting has a 1‑1/2" (50mm) NPT thread.
▪
A vertical vent
e
must be installed that extends above the exhaust vent.
▪
The rear access panel
f
must be accessible when the installation is complete.
▪
All materials must withstand temperatures up to 200°F (93°C).
▪
If PVC piping is used, CPVC cement is required.
NOTICE:
In the U.S.A., this equipment is to be installed to comply with the Basic Plumbing
Code of the Building Officials and Code Administrators International, Inc. [BOCA],
and the Food Service Sanitation Manual of the Food & Drug Administration [FDA].
What you will need
NOTE: all items are included in the Alto-Shaam installation kit, or must be provided by the
installer.
Piping included in kit can be cut to create the shaded configuration shown on the next page,
with a maximum drain run of 4-1/2' (1372mm). Piping for air gap must be provided by the
installer.
▪
Union with 1-1/2" (50mm) NPT female connection
▪
1-1/2" (50mm) ID piping and elbows
To install the water drain, follow these steps.
Step Action
1. Install
the
union
d
.
2. Cut
piping for the drain vent
e
.
3. Install
the vent bracket included in the installation kit.
a. Position
the bracket
g
at least 1/4" (6mm) above the rear access panel. Mark the screw
holes and remove the bracket.
b. Use
a #30 drill bit
h
to drill screw starter holes.
NOTICE: oven components are located directly behind the rear panel. Do not drill
beyond the depth of the panel wall.
c.
Use
the self-tapping screws in the installation kit
i
to install the bracket.
4. Cut
the piping for the drain run
b
and install the piping.
5.
Install
an air gap
a
above the drain floor sink
c
.
The water drain for the oven is now installed.
Install the water
drain