Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 99 / 108

7 Additional information Eder GmbH
98 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
Error Cause Remedy Chapter
Front ambient
lighting does not
work
Status LEDs on
power unit
illuminated red
Status LED no. 21
must be green,
contact specialist
workshop if
necessary.
see "Power unit",
page 83
Rear ambient
lighting does not
work
Do not engage
reverse gear
Reverse gear must
be engaged
Attention, the rear
ambient lighting
cannot be used
when the vehicle
is stationary and
the engine is
running.
see "All-round
lighting*, worklights*
and ambient lighting
front* and rear*",
page 46
Check status
LEDs on power
unit
Status LEDs no. 19
and 20 must be
green, if necessary
contact truss instead
of
see "Power unit",
page 83
Additional rear
lights in the
warning console
do not function
Satus LEDs on
power unit light up
red
Status LEDs No. 01,
02, 07 and 24 must
be green, contact
specialist workshop
if necessary.
see "Power unit",
page 83
Trailer lighting for
the relay ball on
the plateau does
not light up
Satus LEDs on
power unit light up
red
Status LED no. 24
must be green,
contact specialist
workshop if
necessary.
see "Power unit",
page 83
Trailer light of the
trailer hitch at the
rear does not light
up
Fuse defective Check fuses on the
construction vehicle
and replace if
necessary.
Operating
instructions base
vehicle
Eder GmbH 7 Additional information
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 99 / 108
To check the control LEDs on the sensors, look straight at the LEDs. If
the viewing angle is too oblique, the LEDs cannot be detected.
Images sensors
Tilt sensor at the rear lower end of the
plateau
Sensor end position tipping shear
attached to the side of the tipping shear
Sensor tilt scissors closed at the rear
between the side cheeks of the tilt scissors