Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 71 / 108

5 Care and
maintenance
Eder GmbH
70 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
The values for tire pressure may vary slightly depending on tire size and
base vehicle. If no values of the base vehicle are available, a tire pressure
of 4.5 bar can be assumed as an average value.
5.4.2 Air suspension
The car transporter is equipped with an uncontrolled air suspension on the rear axle. One
spring bellows is mounted on each side. The spring bellows is mounted on the tandem
chassis in an oscillating manner. The left and right bellows are not connected to each other.
Check the pressure in the spring bellows.
•
The pressure in the spring bellows must be checked weekly or after the pressure
monitoring system has responded and corrected if necessary.
• The filling connections are located at the front left of the plateau next to the winch*,
one filling connection each for the left and right side.
• The inflation connections are commercially available tire inflation connections.
• The filling pressure is at empty plateau (empty weight of the car transporter) and
to be checked with the axle not lifted.
Filling pressure of the spring
bellows with empty weight and
unlifted axle: 3.0 bar
Filling connections Spring bellows:
1. Left side
2. Right side
The filling pressure at empty weight is exceeded!
If the filling pressure is too high, the bellows may burst during
operation and with high loads.
° Make sure that the filling pressure is not exceeded.
Eder GmbH 5 Care and
maintenance
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 71 / 108
To reduce diffusion from the spring bellows, it is recommended to fill the
spring bellows with pure nitrogen or a tire inflation gas.
Pressure monitoring spring bellows
For safety reasons, the pressure of the uncontrolled air suspension is monitored. The
left and right sides are monitored separately.
•
•
If the pressure in one of the two bellows falls
below 2.5 bar, the service lamp (1) flashes.
• In addition, "L" (2) or "R" (3) indicates on which
side the pressure is too low.
If the pressure in one of the spring bellows is too
low, an additional warning tone sounds for
approx. 10 seconds when the ignition is
switched on.
Touch panel in the driver's cab:
1. Service lamp
2. Left side
3. Right side