Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 24 / 108

4 Operation and running Eder GmbH
24 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
The wheel stop is not fastened properly!
The wheel stop can come loose while driving.
°
Make sure that the pins of the wheel stop are fixed in the holes
of the railing.
The turnbuckle must be able to be closed above the dead center
with a decently strong hand pressure, but without force. If
necessary, change the setting of the turnbuckle by screwing the
eyelet in or out further.
°
•
Load the vehicle to be transported ( see "Loading without winch*", page 25 or
"Loading with winch*", page 26 ). We recommend driving the vehicle forwards
onto the car transporter.
•
The loaded vehicle must be centered on the plateau in relation to the center
longitudinal axis of the car transporter and the parking brake must be applied. The
lowest gear must be engaged or, in the case of an automatic transmission, the
selector lever must be in the P position. The wheels of the front axle must be in
contact with the front wheel stop.
•
Fasten the second wheel stop in the same way as the front wheel stop immediately
behind the rear axle. The turnbuckle must point to the rear.
• A trapezoidal wheel securing strap must be attached at an angle of approx. 45° to all
wheels of the loaded vehicle above the center of the wheel and pretensioned by
means of a ratchet (see illustrations below).
Please also refer to the separate instructions for the harness wheel
securing straps.
•
After a distance of approx. 50 km, the pretension of the trapezoidal wheel lock
belts must be checked and retightened if necessary.