Algema BLITZLADER 2, Руководство по эксплуатации, Страница: 50 / 108

4 Operation and running
4.7 Center ramp*
Eder GmbH
50 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
The center ramp is used for loading and unloading tricycles, trailers with a jockey wheel or
vehicles with a very narrow track. When the center ramp is extended or pulled out, a
continuous ramp is created across almost the entire width of the platform.
1. Operating
handle
2. Middle ramp
3. Plateau
•
•
•
• When the center ramp (2) is deactivated, the operating handle (1) is turned to the left
(as shown). The standard drive-up ramps can be used as described under "Operating
the tilting platform", page 21, without affecting the center ramp (2).
To activate the center ramp (2), the side drive-up ramps must be completely
retracted. If the center ramp (2) is activated with the drive-up ramps partially or
completely extended, the actuating mechanism does not engage until the center ramp
is completely retracted.
The center ramp (2) is activated by turning the operating handle (1) 180°
counterclockwise as far as it will go.
• The center ramp (2) now extends and retracts synchronously with the side loading
ramps.
• To deactivate the center ramp, the drive-up and center ramps must be fully retracted.
The operating handle (1) must be turned clockwise by 180° until it is against the stop.
The center ramp is thus deactivated and locked in the retracted position.
The center ramp must be fully retracted when deactivating. If the
center ramp is deactivated when the drive-up and center ramps are not
fully retracted, functional failures and damage to the actuating
mechanism may occur.