Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 62 / 108

°
Protect yourself adequately against moving traffic.
The identical measures must be applied as for loading and
unloading ( see "Loading and unloading point", page 20 ).
62 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
4 Operation and operation Eder GmbH
•
Then stow the jack, tools and the defective wheel.
• Check the tightening torque of the wheel bolts again after 50 km.
The car transporter can slip off the car lifter during the wheel
change!
Persons lying under the car transporter can be crushed.
°
°
Use jacks with a rubberized support surface or place a suitable
anti-slip mat on the support surface of the jack.
° When lifting, make sure that the support surface of the jack does
not slip. This can happen, especially in the case of a tilting trolley
jack, due to the circular movements of the lifting arm.
Never lie down under the car transporter during the wheel
change.
° Do not reach further under the car transporter than absolutely
necessary for the wheel change.
The wheel bolts are not tightened with the correct torque!
The wheel may come off after the wheel change.
The rim, wheel bolt or wheel hub may be damaged.
°
Tighten the wheel bolts with a torque wrench. Refer to the
operating manual of the base vehicle for the tightening torque. It
is identical for both rear axles.
If no torque wrench is available when changing the wheel, the
tightening torque must be checked as quickly as possible in a
suitable workshop.
Wheel change with loaded car transporter!
The axles or wheels can be overloaded and damaged.
° The wheel change with loaded car transporter is not allowed.
Unload the car transporter before changing the wheel.
Flowing traffic when changing wheels on public roads!
Accidents with personal injury and property damage may occur.